Metal Roofing in Pembroke Pines

Why metal wins in South Florida

• Wind. Standing-seam systems test to 160–180+ mph — the highest ratings available for residential roofing. In a hurricane zone, that margin matters.
• Lifespan. 40–70 years in our climate. It's plausibly the last roof you'll buy.
• Heat. Metal reflects solar heat far better than dark shingles or tile, which your attic (and your FPL bill) will notice.
• Insurance. A new metal roof with strong wind mitigation features earns some of the best premium credits available.

The salt-air details that separate good from bad

Pembroke Pines is inland, which spares metal some coastal punishment — but salt air still travels, and the details decide whether a metal roof lasts 60 years or 20:

• Panel and coating selection rated for the exposure — we spec systems with real coastal track records, not just inland warranties.
• Fastener strategy. Standing seam's concealed fasteners are the whole point: no exposed screws to back out and leak. On any exposed-fastener details, we use corrosion-appropriate fasteners.
• Galvalume warranty awareness. Some manufacturer warranties exclude or limit coverage within a half-mile of salt water. We tell you exactly what your warranty covers before you sign.
• Flashing and trim in compatible metals — mixed metals corrode each other, and we don't mix them.

Cost, honestly

Standing-seam metal in Broward County runs $1,100–$2,300 per square installed — roughly two to three times architectural shingles. The math that justifies it: one metal roof can outlast two to three shingle roofs, with lower cooling costs and better insurance credits along the way. We'll run the comparison — architectural shingles, tile, metal — with your actual roof measurements so you can decide with real numbers.